The EP Greenhouse gear reducer is a compact and lightweight reduction gear reducer with a built-in limit switch system that’s ideal for assembly of a locally available electric electric motor. The geared motor can be used in manually-controlled or climate-controlled ventilation and screen systems in greenhouses. The quick and easy-to-install EP gear motor is definitely rainproof and windproof. The gear driver has a high protection class (IP65) and can be used within an ambient temperature of 0-60 °C.
The low-noise gear reducer for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel transmitting means that the 
drive shaft is usually locked when the reduction gear motor isn’t running. The completely sealed reduction reducer comes with an growth chamber with a diaphragm to keep carefully the gear essential oil at a minimal pressure under all circumstances, even at high temperature ranges. Thanks to the use of an growth chamber, the reducer could be installed in any placement. There are no restrictions, since there is no need for a bleed plug. The sealed reduction gear driver keeps the apparatus oil of the gear driver in optimum condition because of its entire operating lifetime. The gear driver is ideal for discontinuous use, working course s3-30%, with a maximum activation time of 25 minutes.
The Gear box reduction gear motor comes with an FT85 motor assembly flange, on to which a suitable IEC standard motor can easily be installed (EN 50347).
The Gear box includes a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off by the end positions. The limit switch system is installed within an included chamber and can be enclosed by an impact-resistant plastic cover. The limit change system is accessible and easy to adjust. The limit switch system’s maximum switching range is usually 40 or 64 revolutions of the drive shaft. The cabling is linked in spring-clip connections. The gear driver comes with an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.
The gearbox for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates can be found as accessories.
Maximum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of application of 4-pole electric motor.
Protection class IP65.
May be used in ambient temperatures of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, optimum activation time 25 a few minutes.
Equipped as regular with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC standard motor (EN 50347).
Maximum switching range of limit switch system 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).